Directed DBALL2 Installation Manual page 3

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 1 - with CHTHD1 (R1-R7) /THCHD1 (R1) T-Harness
Refer to the Vehicle Wiring Reference Charts for wire color and location.
Connect parking
lights in drivers
kick panel for
Dodge Journey only.
[1]
Dodge Journey
(+) Parking Lights
White/Violet
85
86
87
87a
30
+12V
Fuse 15A
ONLY connect for
Dodge Journey.
1 2
(MUX)
6 7
Parking Lights:
Pin 1
Headlight switch
(black 10-pin conn.)
Ignition
Barrel
Connected to the Dodge Journey only. DO NOT connect Parking Light Input to (+)12V at the ignition switch.
[1]
All connectors are displayed from the wire side (unless specified otherwise).
This is the only connection required for the
parking light output for the Dodge Journey.
The DBALL MUX connection is not required.
(+) Parking Lights: White/Violet, pin 3
Parking Light Output: Green/Black: 2
[1]
Parking Light MUX Output: Violet/Green: 8
Parking Light MUX Output: Violet/Brown: 9
(-) RAP Off Output: Yellow/Black: 10
3 4 5
(-) Driver Door
8 9 10
Trigger: Violet
CHTHD1 (R1-R7)
/ THCHD1 (R1)
(optional)
12-pin Connector
(harness side)
RF
DBALL2
Prog. Button
LED
Driver
You can connect to either a XL202
Kick
RFTD OR a SmartStart module.
Panel
Refer to the SmartStart/XL202
Installation Notes for more information.
12-pin Connector
12-pin Connector
(harness side)
(Vehicle side)
Rev.: 20170214
Page 3
Hood Pin
Remote Start Safety
Override Switch
6: White/Black: (-) Hood Input
(+) 12V
RX
(-) Ground
TX
© 2017 Directed. All rights reserved.