Disable Or Enable User Prefix; Program User Prefix - Newland NLS-FM420-MS-30 Integration Manual

Prefix/Suffix Prefix/Suffix
General Programming

Disable or Enable User Prefix

User Prefix is added before barcode message. For example, if the user
prefix is "AB" and the barcode message is "123", the Host receives
"AB123".
** Disable User Prefix
【Pro CMD：0305000】

Program User Prefix

Enable "Program User Prefix". Then program user prefix byte(s). To end the prefix,
read "Save programming" The user prefix byte is programmed in its hex values.
See example below.
Note: The maximum length for user prefix is 10 bytes.
Program "CODE" as user prefix (The hex of "CODE" are 0x43/0x4F/0x44/0x45):
1.
2.
3.
4.
5.
6.
appear to the left of a barcode.
nlscan.com
Program User Prefix
【Pro CMD：0300000】
Read "Code Programming ON"
Read "Program User Prefix"
Read "4,3,4,F,4,4,4,5" in order
Read "Save Programming"
Read "Code Programming OFF".
Read "Allow User Prefix" to enable above programming. "CODE" will
Code Programming ON
Code Programming OFF
Enable User Prefix
【Pro CMD：0305010】
Tools
Page 134