Data Formatter; Introduction - Newland NLS-FM420-MS-30 Integration Manual

Data Formatter

Introduction

You may use the Data Formatter to modify the engine's output. For example, you
can use the Data Formatter to insert characters at certain points in barcode data or
to suppress/ replace/ send certain characters in barcode data as it is scanned.
Normally, when you scan a barcode, it gets outputted automatically; however, when
you create a format, you must use a "send" command (see the "Send Commands"
section in this chapter) within the format programming to output data. The maxi-
mum size of formatter commands in a data format is 500 characters. By default,
the data formatter is disabled. Enable it when required. If you have changed data
format settings, and wish to clear all formats and return to the factory defaults, scan
the "Default Data Format" barcode below.
nlscan.com
** Default Data Format
【Pro CMD：0323100】
Tools
Code Programming ON
Code Programming OFF
Page 151