Select Message Length - Newland NLS-FM420-MS-30 Integration Manual

Symbols
Maxicode

Select Message Length

It is used to program the valid reading length of Maxicode. The scanner will not
send barcode message to the Host, if the decoded data length does not match the
valid reading length.
Maxicode Message Length is defined by "Min. Message Length" and "Max.
Message Length ".
Min Message Length (default: 1)
【Pro CMD：0505030】
Max Message Length should not be less than Min Message Length.
To read a fixed length Maxicode, Please program Max & Min Message Length to the same
value.
To set Min Message Length of Maxicode to 8 bytes and Max Message Length to 12
bytes, read these programming codes.
1. "Code Programming ON"
2. "Select Min Message Length"
3. Digit Code "8", see Digit Code
4. Save Programming", see Digit Code
5. Select Max Message Length"
6. Digit Code "1"
7. Digit Code "2"
8. "Save Programming"
9. "Code Programming OFF"
nlscan.com
Code Programming ON
Code Programming OFF
Max Message Length (default:150)
【Pro CMD：0505040】
Tools
Page 126