System Configuration Interface Setup - AMX DGX1600-ENC Hardware Reference Manual

System Configuration Interface Setup

System Requirements
□
Minimum web browser requirements – Google Chrome v30, Internet Explorer v10, Firefox v24, Safari v6.0, Opera v24, or other
browser with substantial support for HTML5 features
NOTE: User experience may differ due to browser support for HTML5.
Setting up the system to use AMX's System Configuration interface requires completing the following three items. Detailed
instructions for each item are given.
□
Determine the integrated Master's IP address via the front Control Panel
□
Open a web browser on the PC*
□
Open the System Configuration interface
* The PC (or tablet) must be on the same LAN that the enclosure is connected to via the LAN 100/1000 port (i.e., if the enclosure
is connected to an internal enterprise network, the PC must be as well).
NOTE: The steps below assume that the Enova DGX is powered on and connected to the public LAN via the LAN 100/1000 port on the
enclosure's CPU.
NOTE: Place source and destination devices within view until the test switch confirms correct routing behavior. Any applicable
modules/wallplates should be correctly installed and power must be applied to both the enclosure and source and destination
devices.
To log on to the System Configuration interface and execute a test switch:
NOTE: The System Configuration interface can also be launched via NetLinx Studio (see page 179).
1. Determine the integrated Master's IP address:
On the front Control Panel, locate Setup Options by scrolling with the Control Dial.
a.
Press the Select key.
b.
Locate IP Address by scrolling with the Control Dial.
c.
Press the Select key to display the IP Address.
d.
Record the IP address for use in Step 3.
e.
2. On a PC or tablet, open a web browser that supports HTML5.
3. In the web browser's address bar, enter the Enova DGX's IP address and press Enter.
The System Configuration interface's Home page appears in the browser.
IMPORTANT: The default Username for the interface is "administrator" and the default Password is "password." After initial setup,
defaults should be changed to ensure system security.
4. From the main menu bar at the top of the screen, select Switcher>Switching.
The Switching page appears.
5. Disconnect the factory default switch (Input 1 routed to all Outputs):
Click Input 1.
a.
Under outputs, select Deselect All.
b.
Click Take.
c.
6. Make sure the first two source devices and the first two destination devices are connected to the first two input and output
connectors (for specific board connector information and specifications, see the board chapter).
7. Route Input 1 to Output 2 (click Input 1, then Output 2, then click the Take button).
8. To verify the switch, click Input 1 again. Both the Input 1 and Output 2 buttons will turn blue and both selections will appear in
the Selected pane on the right.
9. Disconnect the test switch (click Output 2 and click Take) and finish the installation.
For System Configuration interface tips, see page 163.
NOTE: For instructions on executing a test switch via BCS Commands, see the "BCS (Basic Control Structure) Protocol Programming
Guide" at www.amx.com.
The following sections contain information on additional setup options:
Audio Control and Signal Processing (see the following page)

Establish serial communication with a PC via the Program port (see page 56)

Attaching an AxLink device (see page 57)

Using the ID Pushbutton (see page 59)

Enable Program Run Disable (PRD) Mode (see page 60)

Hardware Reference Manual – Enova DGX 100 Series Digital Media Switchers
Installation and Setup
55