Konica Minolta magicolor 7450 Service Manual page 158

Field Service Ver. 1.0 May 2006
(4) DEFAULT GATEWAY
Function • Sets the gateway address of the printer used in the network.
Use • To set the printer's gateway address.
Setting 1. Select [DEFAULT GATEWAY] and press the MENU/SELECT key.
/procedure 2. Set desired DEFAULT GATEWAY ADDRESS (first bite) with the Up key /Down
key
3. Repeat the above procedures and set the DEFAULT GATEWAY ADDRESS up to
fourth bite.
4. Press the MENU/SELECT key.
• The default setting is "000.000.000.000."
(5) DHCP/BOOTP
Function • DHCP: Automatically acquires an IP address from the DHCP server, if there is one
• BOOTP: Automatically acquires an IP address from BOOTP and specifies whether to
• To automatically acquire an IP address and load other network information.
Use YES : Enable IP auto acquisition setting.
No
Setting • The default setting is ON.
/procedure
NOTE
• When [TCP/IP/IP ADDRESS] is enabled, the [DHCP/BOOTP] setting is changed
to [OFF."
• When IP address is not allocated from the server, [TCP/IP/IP ADDRESS] is set
automatically set within the range "169.254.0.0. to 169.254.255.255."
(6) TELNET
Function • Select whether to enable or disable TELNET transmissions.
Use • To specify that the printer is connected by TELNET transmissions.
Setting • The default setting is ENABLE.
/procedure
B. NETWARE
(1) ENABLE
Function • Enables NetWare.
• To specify that the printer is connected to a NetWare network.
Use YES : Enable NetWare. Printing can be done via NetWare.
No
Setting • The default setting is YES.
/procedure
and press the Right key .
000.000.000.000 to 255.255.255.255
in the network, and specifies whether to load other network information.
load other network information.
: Disable IP auto acquisition setting.
"ON"
"ENABLE"
: Disable NetWare. Printing cannot be done via NetWare.
"YES"
9. Menu
OFF
DISABLE
"NO"
121