Set Heading - Sherwood Scuba SAGE Manual

SET HEADING

Pressing the Advance button while on the Compass Main screen will set a heading. The message HEADING SET is confirmation of your heading be-
ing set. The heading is then represented by a green marker. Pressing the Advance button a second time will set the reverse (reciprical) heading. The
(reverse) heading is also represented by a green marker. The heading marker will appear amber when your direction drifts from either a heading or
reverse heading. An amber arrow will also point in the direction you should turn to correct your course. The heading can be removed at anytime by
holding the Advance button for at least 2 seconds.
75
N
ON HEADING
(heading set to 281˚)
63
281°
REF
FT
281°
W
SW NE
ALARMS
When most alarms are triggered, operation in Compass Mode will be terminated and the Dive Main screen will be displayed describing the alarm
condition. Compass Mode can then be reentered by holding SELECT for 2 sec.
© Pelagic, 2017
SET HEADING
FT
049°
E
NE
to set heading
(or reverse heading if
heading is already set)
63
reference
heading
NE
63
SW
remove
heading
ON REVERSE HEADING
(heading set to 100˚)
100°
REV
FT
100°
E
SE
56
HEADING IS SET
281°
REF
FT
281°
W
NE
OFF HEADING
course
(heading set to 281˚)
correction
56
arrow
FT
079°
reverse
heading
NE
Doc. No. 12-7864-r06 (8/21/17)
SAGE MANUAL
281°
REF
E
SE