Overview - Sherwood Scuba SAGE Manual

OVERVIEW

The Sage is equipped with an advanced 3D digital compass. Compass Mode can be activated while in AIR/NX or GAUGE operation modes by
holding the SELECT button for at least 2 seconds.
• The Sage reverts back to the previous operation mode after 1 minute unless the Compass Mode is reset by pressing any of the buttons. See the
Timeout section at the end of this chapter for further details.
• When no heading is set, the heading degrees are in white and the diver's direction (lubber line) is green.
• Once a reference or reverse heading is set, the heading degrees, heading marker, and diver's direction (lubber line) are green when on heading
and amber when off heading.
NOTE: Similar to an analog compass, magnetic and ferrous metals can cause erratic and erroneous readings.
WARNING: You must become thoroughly familiar with setup and operation of the Sage Digital Compass before using it as your primary device
for navigation. Failure to do so could result in serious errors relating to activities involving navigation.
COMPASS MAIN
(while on surface,
heading set to 76˚)
2:39
SURF
REF
TIME
283°
W
SW
to Compass Menu
© Pelagic, 2017
76°
to
Surface
Main
NE
remove
heading
to set heading
(or reverse heading if
heading is already set)
COMPASS MAIN
(during a dive,
no heading set)
75
FT
049°
N
NE
53
SAGE MANUAL
to
Surface
Main
E
remove
heading
to set heading
(or reverse heading if
heading is already set)
Doc. No. 12-7864-r06 (8/21/17)