Sherwood Scuba SAGE Manual page 7

Battery Removal
• Locate the battery cover on the end of the housing.
• Apply a coin to the recessed slot of the cover and turn it counterclockwise out of the housing.
• Remove the Battery and discard it according to local regulations governing disposal of Lithium batteries.
REMOVE COVER
Inspection
• Closely check all of the sealing surfaces for any signs of damage that might impair proper sealing.
• Closely examine the battery cover and housing for any signs of damage that might prevent proper threading.
• Closely examine the inside of the battery compartment for any signs of corrosion indicating entrance of moisture into the unit.
• Inspect the buttons, lens, and housing to ensure they are not cracked or damaged.
WARNING: If damage or corrosion is found, return your Sage to an authorized Sherwood dealer, and DO NOT attempt to use it until it has
received factory prescribed service.
• Remove the cover O-ring by squeezing the sides. Discard, and DO NOT attempt to reuse it.
CAUTION: DO NOT use tools to remove the O-ring. To ensure proper sealing, O-ring replacement is required each time the battery is replaced.
REMOVE O-RING
Battery Installation
CAUTION: The O-ring must be a genuine Sherwood part that can be purchased from an authorized Sherwood dealer. Use of any other O-ring
will void the warranty.
• Very lightly lubricate the new O-ring with silicone grease. Install it onto the battery cover. DO NOT roll the O-ring over the threads, instead stretch
it slightly to work it down over the slotted end of the cover into the groove at the base of the threads.
• Insert a new or rechargeable battery, positive (+) side first, into the battery compartment with the negative end facing out.
• Ensure that the battery is properly installed and the cover O-ring is evenly seated around the cover.
• Carefully place the cover (with spring) into the housing and turn clockwise slowly by hand to ensure proper threading.
• Apply a coin and tighten the cover by turning it clockwise until secure. The outer surface of the cover should be flush with the outer surface of the
housing.
CAUTION: Once the battery cover is installed, the Sage will prompt you to choose the correct battery type. The choices are rechargeable or
non-rechargeable. The Sage will measure the battery and make a best guess of the battery type. Though it is up to the diver to ensure the proper
selection is made. The Sage will not measure the battery life correctly, shutting off unexpectedly without warning, if the wrong battery type
selection is made. If the wrong selection is made accidentally, simply loosen the the battery cover again and repeat the previous steps.
INSTALL O-RING
© Pelagic, 2017
REMOVE BATTERY
REPLACE BATTERY
7
SAGE MANUAL
INSTALL COVER
Doc. No. 12-7864-r06 (8/21/17)