Set 1 Group (Modes/Basics); Set Operating Mode - Sherwood Scuba Insight Manual Manual

Pressing and releasing the S button momentarily (< 2 sec each time) steps through the SET 1 (Fig. 33),
SET 2, SET 3, SET 4 GO TO screens. SET 2, 3, and 4 screens are similar to SET 1.
While a SET GO TO screen is displayed, you have up to 2 minutes to press and release the A button
(< 2 sec) to access the first selection of that Set Group.
A
S

SET 1 GROUP (MODES/BASICS)

Fig. 33 - Set 1 Group

SET OPERATING MODE

Factory set for AIR, the INSIGHT can also be set for NITROX or GAUGE.
Appearing on the screen are (Fig. 34) -
Fig. 34 - Set MODE
38
> Pressing and releasing the S button (< 2 sec) 1 time while the SET GO TO screen is displayed,
accesses the SET 1 GO TO screen.
> Pressing and releasing the A button while the SET 1 GO TO screen is displayed, accesses the
Set Operating MODE screen with the Set Point flashing.
• Alpha graphic MODE
• Graphic Air, or NITROX icon, or graphic GAU, flashing
> Pressing and releasing the S button (< 2 sec) step through the Set Points.
> Pressing and releasing the A button (< 2 sec) saves the Set Point.
• If Nitrox is selected, operation advances to SET PO2 ALARM VALUE.
• If Air or Gauge is selected, operation reverts to the TIME/WET screen.
> Depressing both buttons for 2 seconds reverts to the TIME/WET screen.
• Operation reverts to the TIME/WET screen if neither button is pressed in 2 minutes.