Advertisement

Where Depth of Experience Produces the Height of Innovation.
OWNER'S MANUAL
MAGNUM
SRB5300
®
www.SherwoodScuba.com

Advertisement

Table of Contents
loading

Summary of Contents for Sherwood Scuba MAGNUM SRB5300

  • Page 1 Where Depth of Experience Produces the Height of Innovation. OWNER’S MANUAL MAGNUM SRB5300 ® www.SherwoodScuba.com...
  • Page 2 The owner’s manual uses signal words recommended by the American National Standards Institute (see ANSI Z535.4) to designate levels of hazard seriousness. These signal words and their designations are as follows: DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
  • Page 3: Table Of Contents

    3.0 Routine Maintenance & Handling Tips ......6 3.1 Pre-Dive Checks..............7 3.2 Post-Dive Care ...............8 4.0 Sherwood Scuba Limited Warranty Information ..... 9 4.1 Two Year Limited Warranty ............9 4.2 Disclaimer & Limitation of Remedy ........11 4.3 Things You Should Know About Your Two Year Limited Warranty ..........12...
  • Page 4: Introduction - Simply Reliable

    1.0 INTRODUCTION - SIMPLY RELIABLE. Congratulations! You are now the owner of a new Sherwood Scuba regulator. You’re about to experience the Sherwood difference in diving equipment...regulators that are simply reliable. At Sherwood, we focus on the type of diving you do, then design products that address your specific needs.
  • Page 5: Safety Information

    2. Sherwood regulators must be serviced only by dealers or persons trained and authorized to service Sherwood Scuba equipment. At no time should any unauthorized person attempt to repair the regulator or adjust any nuts, bolts or screws other than those used to mount the regulator to, or dismount it from the tank valve.
  • Page 6: Important Cautions

    3. The high pressure outlet is normally marked “HP” (on current Sherwood Scuba regulators, the high pressure outlets are distinctly larger than the low pressure outlets and are clearly marked “HP”). If the regulator outlet is not marked, install a submersible pressure gauge in the outlet and test the pressure with a full tank of air.
  • Page 7: Pre-Dive Checks

    3.1 PRE-DIVE CHECKS WARNING It is safe diving practice to inspect your regulator before each use. Check for signs of damage, loose parts, or possible malfunction. If you detect a problem, have the regulator properly serviced by an authorized Sherwood Scuba dealer before you use it agian.
  • Page 8: Post-Dive Care

    If no air is escaping from the valve when air pressure is applied to the first stage, you should have the regulator inspected by your authorized Sherwood Scuba dealer. CAUTION Lifting the tank by the regulator or hoses may loosen a previously tight connection, which could cause unexpected air loss and put the diver at risk during a subsequent dive.
  • Page 9: Sherwood Scuba Limited Warranty Information

    4.1 TWO YEAR LIMITED WARRANTY 1. Sherwood warrants that Sherwood Scuba regulators purchased from authorized Sherwood Scuba dealers shall be free from defects in materials and workmanship for twenty-four (24) months from that date of original purchase. Under this limited...
  • Page 10 Sherwood’s products. 4. This limited warranty applies only to regulators sold through authorized Sherwood Scuba dealers. Authorized Sherwood Scuba dealers do not sell Sherwood Scuba regulators through mail order. 5. This limited warranty shall be void if the regulator has been misused, abused, altered, changed, or modified.
  • Page 11: Disclaimer & Limitation Of Remedy

    Sherwood recommends that you have your regulator inspected once a year on the anniversary date of its purchase at any authorized Sherwood Scuba dealer worldwide. Sherwood Scuba equipment should be used by certified scuba divers only.
  • Page 12: Things You Should Know About Your Two Year Limited Warranty

    5.0 MAGNUM SRB5300 FEATURES FIRST STAGE 1. Like all current Sherwood Scuba regulators, the Magnum is equipped with Sherwood’s patented Dry Air Bleed System. This unique feature accomplishes the very important task of keeping the interior of the first stage, including the main spring chamber,...
  • Page 13: Second Stage

    clean and dry. The Dry Air Bleed System helps give the first stage durability, stable output pressure. and outstanding resistance to cold water freezing effects. 2. Optimized internal porting maximizes flow rate capability to supply an appropriate air supply for high work efforts encountered during some dives.
  • Page 14: Specifications

    6.0 SPECIFICATIONS REGULATOR MODEL ........Magnum SRB5300 AIR FLOW ........... 33 cu. ft./min. (935 liters/min) @ 1 atmosphere INHALATION RESISTANCE......1.0” WC (2.5 cm WC) @ 1 atmosphere EXHALATION RESISTANCE ......7” WC max. (1.8 cm WC) @ 1 atmosphere FIRST STAGE REGULATOR TYPE ............
  • Page 16 Middlesex HAO 1 WU Notified Body No. 0120 Meets EN250 Standards Sherwood Scuba, the S-Ball and Magnum are trademarks of Sherwood Scuba,LLC. All other names are trademarks of their respective owners. © Copyright 2003 Sherwood Scuba , LLC. ® All products are subject to change without notice...

Table of Contents