Set Gas - Sherwood Scuba SAGE Manual

1. SET GAS

Within this submenu you can change the available gas mixes from OFF, AIR, or to any nitrox mix between 21 - 99 % O
O ) . If you save a nitrox mix value for any gas, a Set Gas# PO
2
The corresponding MOD (Maximum Operating Depth) will display with the current PO2 Alarm setting for the selected gas. Addition-
ally, the Sage allows for each gas (1 - 3) to have individual PO
Default settings are FO
elapse without conducting a dive.
NOTE: Once any Gas is set for Nitrox, any other Gas set for AIR will automatically be set to 21%. The AIR option will not be displayed as
an FO setting until 24 hours elapse after the last dive.
2
NOTE: When FO2 is set for AIR, oxygen related data (such as PO2, % O2) will not be displayed at any time during the dive, on the sur-
face, or in Plan Mode. Though these oxygen values will be tracked internally for use in any subsequent nitrox dives.
NOTE: Gas 1 cannot be set to OFF.
NOTE: Gases 2 and 3, when selected during a dive, will display SPG (Submersible Pressure Gauge) intsead of a pressure reading on
the Dive Main screen.
SET GAS MENU
GAS3 OFF
GAS1 AIR
GAS2 NX 32
to scroll
up
SELECT MAX PO2
(bypassed if gas is set for AIR)
SET GAS2 PO2 MAX
1.30
MOD: 132 FT
1.20 - 1.60
to decrease
value
© Pelagic, 2017
Air with no PO alarm value for Gas 1, and OFF for Gas 2 and 3. Settings revert to the defaults when 24 hours
2 2
to select
option
to scroll
down
to save
setting
available
settings
to increase
value
Max screen will display. You can then set a Max PO
2
alarm settings.
2
SET GAS1
AIR
AIR, 21% - 99%, O2
to decrease
value
21
SAGE MANUAL
or O2 (100%
2
warning alarm.
2
to save
setting
available
settings
to increase
value
Doc. No. 12-7864-r06 (8/21/17)