Table of Contents
Advertisement
onlIne led (green)
This light indicates that the Sentinel Pro unit is communicating with the Sentinel Pro servers.
standby led (yelloW)
This light indicates that the Sentinel Pro unit is in standby mode.
aCknoWledge/ standby button
When an unacknowledged alarm exists (as indicated by a blinking red alarm LED), briefly press the but-
ton and the alarm LED will stop blinking, indicating that the alarm is acknowledged. To enter Standby
mode, press and hold the button for at least 5 seconds until the Standby LED lights up, then release. To
exit from Standby mode, hold the button down for 5 seconds until the Standby LED turns off.
InsTallaTIon
This section provides information on:
• Operating environment
• Installation
• Connecting sensors
• Network Configuration
parts requIred
• Screwdriver and #8 screws
• Network Hub, Switch, or Router that supports 10 or 100 BASE-T with internet access
• Computer w/Internet Connection
operatIng enVIronMent
Before you install the Sentinel Pro be sure that your operating environment meets the physical require-
ments of the equipment.
Operating Temperature:
Humidity:
Power:
poWer
Connect the included DC power supply to the power jack on the Sentinel Pro. Plug the power adapter
into a 115V AC power outlet.
netWork ConFIguratIon
The Sentinel requires an Internet connection to operate. Using the included network cable, connect the
Sentinel to your 10/100 network hub, switch, or router. Note that your network must support DHCP for
initial configuration. You can change it to a Static IP later if required (see chapter 2). The green ONLINE
LED should light up within a few minutes indicating that the device has connected to the Sensaphone.
net servers.
Technical Info: The Sentinel communicates over port 443 (the standard TCP port that is used
for websites which use SSL encryption), so this must be open for outbound communication. The
device also makes use of port 123 for clock synchronization (NTP), so this must be open for
UDP outbound.
32º –122º Fahrenheit (0º– 50º C)
5– 90 %RH, non-condensing
115VAC 50/60 Hz outlet within 6'
Chapter 1: Installation
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Sentinel Pro and is the answer not in the manual?
Questions and answers
How do you add users?
To add users to Sensaphone Sentinel Pro:
1. Go to the "Manage Users" page.
2. Add alarm users to your account.
3. To group users, go to the "Manage user groups" section.
4. Select an existing group or click "Create New Group."
5. Give the group a unique, descriptive name.
6. Click the plus icon to add users from the list of alarm users.
7. You can add an entire user or select individual destinations.
8. Click the red X icon to remove users if needed.
9. Click "Save Group" when finished.
This answer is automatically generated