Other Issues; Modules Reporting A Fault - Honeywell touchpoint pro Operating Manual

POTENTIAL OPERATING ISSUES
Category
User Interface
(Touchscreen)
User Interface
(Touchscreen)
GUI
(Webserver)
Web Server
Web Server
Web Server

10.2 Other Issues

10.2.1 Modules Reporting a Fault

If the system detects a module fault, the fault will be reported on the screen and the module's LED will change colour to
orange.
If the fault is transient in nature – possibly due to low power supply voltage or to ring communication problems – the module
will return automatically to normal operation when the fault is cleared.
When the system detects a module fault, that module will be set to a safe state. If this happens, the module stops
communicating on the ring and takes its inputs / outputs to the defined 'safe' state e.g. it turns off mV bead current and takes
relays to a power-off state. See Ch.19 Ring Communication Errors for further information.
A failed module will generate ring fault reports, module fault reports and channel fault reports. The channels either side of it
will also report lost communications, but will not be shown as faulty. See Ch19.4 Ring Fault Diagnostics and Debugging
Techniques for further information.
The module should only be replaced if the fault is not due to low power or a ring problem in another part of the system.
Contact your local service representative for help if required.
Note: it may be possible to restore module operation by physically removing and refitting the module to disrupt its power
supply. However, you should contact your service representative for advice as the recovery may only be temporary.
Pt. No. 2400M2566_1_EN
Fault / Problem Possible Cause
Screen does not Internal
respond to touch communication
issue
Screen does not Screen calibration The touch screen may require recalibration.
respond to user
input as expected
'Web browser MS Windows
already open' limitation:
error message Browser does not
fully shut down on
exit, or other
instances remain
open on exit
No Web Server
connection
Communication The Touchpoint
with the Controller Pro Controller is
is lost busy, or the
network has been
interrupted.
Slow / intermittent The Web Server
response from the supports 5
Touchpoint Pro concurrent web
system clients, however it
does not restrict
further users from
connecting
Table 14.
Remedial Action
1) On the front panel, select the Accept and Reset
buttons together for >10 s to reset the Communication
Board.
2) Contact your service representative if this fails.
Use Task Manager to close the browser or select
CTRL+ALT+DEL>Start Task
Manager>Processes>[Your browser]>End Process
Close Task Manager and relaunch your browser.
Verify that the TPPR has a valid Webserver licence.
Check TCP/IP settings, check if the PC network adapter
is enabled, check proper cable connections. The
Ethernet port of the Touchpoint Pro Control Module
should be connected to a network. Please refer to
Ch.5.2 Cabling Requirements for further information.
If possible, check the TPPR Touchscreen for any
instruction or detailed error message.
A system operation such as power up, backup or restore
may be in progress. Allow time for completion and retry.
Reduce the number of web clients to five or below.
Potential Issues
62
Touchpoint Pro
Operating Manual