Honeywell touchpoint pro Operating Manual page 77

POTENTIAL OPERATING ISSUES
Error Message
Code
56 Entered span gas concentration
is out of range - please edit and
try again
57 Operation failed; invalid object
type
58 Operation failed; CRC
calculation timeout
59 Operation failed; a session has
already been opened by another
user
60 The session has expired - new
user login required
61 Not used
62 Not used
63 Operation failed; CRC error
occurred for safe data.
64 Operation failed; CRC error
occurred
for non-safe data.
65 Operation failed; session does
not exist; user login required
66 Operation failed; CCB did not
respond within the expected
time interval.
67 Configuration read / write
request failed; FLASH memory
operation timeout
Pt. No. 2400M2566_1_EN
Possible Cause Remedial Action
The span gas 1. Check the configured limits for span gas
selected is not within concentration.
the configured limits 2. Obtain an alternative span gas that is within
the limits.
3. Retry the operation.
There has been a 1. Please retry the operation.
communication error 2. If still unsuccessful, on the front panel, press
between the CCB and the Accept and Reset buttons together for 10 s,
COB which will restart the COB.
3. If the error has not cleared, if possible cycle
the power to the system.
4. If the problem persists, please contact your
local service representative.
There has been a file 1. Please retry the operation.
transfer error 2. If still unsuccessful, on the front panel, press
between the CCB and the Accept and Reset buttons together for 10 s,
COB which will restart the COB.
3. If the error has not cleared, if possible cycle
the power to the system.
4. If the problem persists, please contact your
local service representative.
Another user may be 1. Check if another user is logged in.
logged in via one of 2. If your requirement takes priority, you have
the alternative the option to terminate the existing (other
interfaces (local user's) session.
Touchscreen or PC
Configuration
Software)
A user login will time The system will automatically request a new
out after 20 minutes login
of inactivity
— —
— —
Refer to Error 2 Refer to Error 2
———//——— ————————//————————
User login is required The system automatically requests a new login.
before carrying out The user may have been remotely logged out
the intended by another user.
operation
Refer to Error 2 Refer to Error 2
During configuration, 1. Retry the operation.
the CCB was unable 2. If the error has not cleared, if possible cycle
to read or write a the power to the system.
value from / to non- 3. If the problem persists, please contact your
volatile memory local service representative.
68
Sys Sys
Fail Fault
Relay Relay
X
X
X X
X
X X
Touchpoint Pro
Operating Manual