Key Function - AnyTone AT-D868UV Programming Manual

AT-D868UV CodePlug Programming Guide

Key Function

Key Lock:
PF1 Short Key:
PF2 Short Key:
PF3 Short Key:
P1 Short Key:
P2 Short Key:
PF1 Long Key:
PF2 Long Key:
PF3 Long Key:
P1 Long Key:
P2 Long Key:
Long Key Time:
SQUELCH TAIL ELIMINATE (STE)
STE Type CTCSS:
STE When No Signal:
VOX
VOX Level:
VOX Delay:
VOX Detection:
Other
TOT:
Frequency Step:
Language:
SQL Level A:
SQL Level B:
Scan Type:
Mic Gain:
MON Key Function:
Brightness:
Auto Backlight Duration:
GPS:
TBST:
Time Zone:
Standby wait time:
Remote Monitor Funct:
Get GPS Positioning Func: When On, the radio can be called to send its GPS position
Select TX Contact Funct: When On, the radio DMR ID can be changed from keyboard
Auto Repeater:
V-1.18
Select Manual or Auto key lock function
Select from several functions for the radio key below PTT
Select from several functions for the radio key 2 below PTT
Select from several functions for the orange radio key
Select from several functions for the P1 radio key
Select from several functions for the P2 radio key
Select from several functions for the radio key below PTT
Select from several functions for the radio key 2 below PTT
Select from several functions for the orange radio key
Select from several functions for the P1 radio key
Select from several functions for the P2 radio key
Select how many seconds to hold the key for Long duration
Off, Silent or a selected setting
Select Off, 55.2 Hz or 259.2 Hz
Select off or 1 to 3
Select how many seconds of delay
Select built-in mic or external mic or both
Max Total Time of Transmit or Off
In VFO mode, selects the frequency steps
Select language for the programming software
Set the squelch level for the "upper" channel – set at 2
Set the squelch level for the "down" channel – set at 2
Select TO – 5 sec stop, CO – 2 sec stop or SE stops scan
Allows increasing the mic sensitivity
Set to define the function of the side key for "Monitor"
Sets the display brightness – 5 is the brightest
Sets the time the display is on or "off" for always on
Set On or off
Tone Pulse Freq. Selection for opening certain repeaters
Set the GMT time zone for the radio
Set the standby wait time
When On, the radio can be called and start transmitting
without pushing the PTT
When On, changing the TX frequency via keyboard, will also
change RX with correct offset.
Page 16 of 25
©
2017 Trygve Svärd KD0PNQ