AnyTone AT-D868UV Programming Manual page 13

AT-D868UV CodePlug Programming Guide
TX Permit:
Scan List:
TX Prohibit:
Alone:
Talk Around :
Digital
Contact:
DMR/Radio ID:
Color Code:
Slot:
Group List:
Digital Encryption:
Encryption Type:
TDMA:
TDMA Adaptive:
Call Confirmation:
Analog
CTCSS/DCS Decode
CTCSS/DCS Encode
Squelch Mode:
Optional Signal:
DTFM ID:
2Tone ID:
5Tone ID:
PTT ID:
Custom CTCSS:
Once completely filled in, click OK to save this Channel. There is also an option to first
"export" the channel data into a .csv file, and then work the entry of most data in the
excel format. Then save it and "import" back into the codeplug. For large channel data
entries, this may be the easiest method where copy and paste function will allow easier
generation of a lot of channels.
The channel set-up can also be created by first exporting the original channel set-up in
the radio, and then as a .csv excel file edit, copy and paste as many channels and
frequencies you need. As each repeater being programmed may have the same Talk
Groups, working all of this in a excel format and then importing it all back into the radio
is the most efficient method of building a large channel database for the radio.
Note: working the .csv file for channels, the No. column either should be empty, or show
sequential numbers starting with 1 for channel 1, 2 for channel 2 etc.
V-1.18
Select type of transmit function – typically ColorCode
Select which Scan List this frequency belongs to
Check if the frequency is a listening channel only
Check if the "alone" emergency function should be allowed
Check if the TX and RX frequency should be the same
Select the Talk Group this frequency belongs to
Select which of the DMR ID's to use for this channel
Select which CC is related with this channel
Select which slot (1 or 2) applies to this "Contact"
If programmed select which list of channels you want to
listen to, or select NONE to listen to only the programmed
Talk Group for the transmission (TX and RX TG the same)
Select if Off or which number to use
Select which type to use.
Check if working without repeater and using 2 slots
Check if for adaptive slot selection between slot 1 and 2
Check if the receiver has to transmit before accepting calls.
Select Off or CTCSS or DCS and tone frequency
Select Off or CTCSS or DCS and tone frequency
Select how to use the squelch
Select Off, DTFM, 2Tone or 5Tone
Select DTFM ID
Select 2 Tone ID
Select 5 Tone ID
Select off, at start, at end or both
Enter value when requiring a custom CTCSS tone
Page 13 of 25
©
2017 Trygve Svärd KD0PNQ