AnyTone D868UV Firmware Updating Manual

Hide thumbs Also See for D868UV:

Turn off the GPS and APRS functions to prevent the radio from going into TX when

connected to the computer, as it may cause damage to the CPU or memory IC

We have a new driver GD_VirtualComDriver v2.0.2.4944.rar released, some users

who have the driver issue before are able to get the new driver working now.

1. Install USB driver: GD_VirtualComDriver 1.0.1.2118.rar，choose X86 for

32bit system, X64 for 64bit system.

2. In CPS->Set->Set Com, choose the correct com port

3. In CPS-Tool, choose the firmware upgrade.

3. Hold pressing PTT key and PF3 key(top alarm key), at the same time power on

radio, the red LED blink.

4. Use the PC cable to connect PC and radio

5. Click Open Update File，choose 878UV.spi

6. Choose correct Com Port

7. Click Write to update the radio to the latest firmware. After the

firmware update, the radio should return to normal display on screen.

Table of Contents

Need help?

Do you have a question about the D868UV and is the answer not in the manual?

Page 1 Turn off the GPS and APRS functions to prevent the radio from going into TX when connected to the computer, as it may cause damage to the CPU or memory IC Important Notice for Driver We have a new driver GD_VirtualComDriver v2.0.2.4944.rar released, some users who have the driver issue before are able to get the new driver working now.
Page 2 The radio should not return to the Clock-Set screen display after updating, you will have to redo the updating if it returns to the Clock-Set screen display. 8. Reboot the radio when the update is finished. Please put OFF the GPS and APRS to prevent radio go in TX when connect to PC ,as it may cause the CPU or memory IC damage.