Maintenance; Cleaning The Handset; Battery Maintenance; Replace The Color Pad For The Hinge-Type Clip - ASCOM Myco User Manual

User Manual
Ascom Myco Wi-Fi and Cellular Smartphone

18. Maintenance

This chapter includes the following sections:
•

18.1 Cleaning the Handset

•

18.2 Battery Maintenance

•

18.3 Replace the Color Pad for the Hinge-Type Clip

18.1 Cleaning the Handset
Chemical Resistance
The exterior of the handset has been tested and found resistant to chipping, fading, or
wearing off, when the handset is treated with common cleaners, disinfectants, or
perspiration. The following chemicals are safe to use for cleaning the handset:
• 3 % Hydrochloric Acid
• M-alcohol (85 % Methylated Ethanol)
• 60 % Chlorhexidine 0.5 mg/ml
CAUTION: Avoid using acetone to clean the handset, as it damages the handset's plastic
casing.
18.2 Battery Maintenance
Battery Life
Refer to the Battery Storage and Maintenance Guidelines, For Ascom LiIon/LiPol battery
packs document.
18.3 Replace the Color Pad for the Hinge-Type Clip
Pads with different colors can be attached to the hinge-type clip for easy identification of
the handset. The different colors can, for instance, represent a workgroup or a shift.

18.3.1 Remove the color pad

1 On the back of the hinge-type clip, the colored pad is fastened with tabs in two
places. Use a paper clip, or a thin 3-4 mm flat screwdriver, to push against one of the
tabs.
2 Once the colored pad bulges slightly outward (when applying slight pressure to one
of the tabs on the back of the colored pad) use a finger to pull downward from the
center of the colored pad until the pad comes off.

18.3.2 Attach the color pad

1 Align the colored pad with the cut-out for the pad on the hinge-type clip.
2 Attach the pad by pushing down on one end of the pad first. Then do the same thing
on the other end of the pad. Make sure that the color pad is flush to the clip.
3 October 2017 / Ver. H
18. Maintenance
on page 80
on page 80
on page 80
TD 93066EN
80