Install Using Easy Deployment; Install Using Qr Codes - ASCOM Myco User Manual

User Manual
Ascom Myco Wi-Fi and Cellular Smartphone
NOTE: For detailed instructions, refer to the Configuration Manual, Ascom Myco Wi-Fi and
Cellular Smartphone.
Follow the instructions in the applicable section:
•

2.2.1 Install Using Easy Deployment

•

2.2.2 Install Using QR Codes

• 2.2.3 Manual Installation
2.2.1 Install Using Easy Deployment
The handset is automatically installed and configured, if the Wi-Fi system is configured for
Easy Deployment. Refer to the Configuration Manual, Ascom Myco Wi-Fi and Cellular
Smartphone for information on how to configure Easy Deployment in the Wi-Fi system.
If the handset is successfully installed after the Easy Deployment process, but hasn't
received a messaging number automatically, do the following:
1 If the handset is turned On, turn it Off and then On again.
2 When the handset displays: "No messaging number configured for this device", tap
Setup number.
3 When the handset displays "Enter messaging number", enter the number.
CAUTION: If a wrong number is entered, a factory reset must be done, and all handset
configuration parameter settings are restored to the default values. Refer to the
Configuration Manual, Ascom Myco Wi-Fi and Cellular Smartphone.
4 Tap Done.
5 If the Unite system is configured for user login, enter the user ID and password
supplied by the system administrator.
2.2.2 Install Using QR Codes
Quick installation and setup can be done by scanning a QR code, if Easy Deployment is
unavailable. The Setup QR code is created by a system administrator and contains the
parameters necessary to install the handset in the system. Refer to the Configuration
Manual, Ascom Myco Wi-Fi and Cellular Smartphone for instructions on how to create Setup
QR codes.
To scan a Setup QR code, do the following:
3 October 2017 / Ver. H
2. Quick Installation Steps for Administrators
on page 7
on page 7
on page 8
TD 93066EN
7