Use The Ptt Call Screen - ASCOM Myco User Manual

User Manual
Ascom Myco Wi-Fi and Cellular Smartphone
• The invitation is configured to be accepted automatically
• The invitation is of higher priority than the priority of the ongoing call
NOTE: When a PTT invitation has the highest possible priority level (priority 1), the ongoing
call is always disconnected immediately.
If the priority of the PTT invitation is lower than the ongoing call, or if the invitation is not
configured to be accepted automatically, the invitation must be accepted in the same way
as a regular PTT invitation (see
accepted while the call is still ongoing, the call is automatically disconnected.
5.7.2

Use the PTT Call Screen

The push-to-talk call screen is used when communicating in a PTT group call session.
Figure 18. The push-to-talk call screen.
The following options are available during a PTT session:
• Tap and hold Push-to-talk
microphone is muted again when the button is released.
TIP: If configured, the Multifunction button on the top of the handset can also be used as
a push-to-talk button.
• Tap Speaker
buttons to adjust the volume.
• Tap End call
disconnected session, see
NOTE: A PTT session can be terminated remotely by the system. All users are
automatically disconnected from a terminated session.
• Press the Home button to hide the call screen temporarily, without disconnecting from
the PTT session. Information about the ongoing session is displayed in the phone bar
(see 5.4.11 The Phone Bar
button
same way as on the call screen.
3 October 2017 / Ver. H
5. Calling
To Accept a PTT Invitation
to open the microphone for transmitting. The
to enable/disable the loudspeaker. Use the Volume up, or Volume down
to disconnect from the PTT session. For instructions on how to rejoin a
5.7.4 Rejoin a PTT Call Session
on page 40 for details about the phone bar). The push-to-talk
on the phone bar can be used to open the microphone for transmitting, in the
TD 93066EN
on page 42). If the invitation is
on page 44.
43