Directly On The Camera - GeoVision GV-VD120D Quick Start Manual

1.5.2 Directly on the Camera

1. Keep the power and network cables (or PoE) connected to the camera.
2. Use a pin to press and hold the default button on the inner housing.
3. Release the default button when the status LED blinks. This shall
take about 8 seconds.
4. When the status LED fades, the process of loading default settings is
completed and the camera reboots automatically.
Figure 1-18
5. Insert a new Silica Gel Bag and fasten the camera's cover
immediately.
20
Vandal Proof IP Dome (Part I)
1
Default button
Status LED