Power Connection - GeoVision GV-VD120D Quick Start Manual

1.4.2 Power Connection

There are two ways to supply power to the camera:

Use a Power over Ethernet (PoE) adapter to connect the camera to the
network, and the power will be provided at the same time.

Plug the power adapter to the 12V terminal block as shown below.
1. Insert the thin black wire of the Vandal Proof IP Dome to the left
pin (-) and the red wire to the right pin (+).
Figure 1-14
2. Connect the DC 12V Power Adapter to the Terminal Block.
Terminal Block
Vandal Proof IP Dome (Part I)
1
DC 12V Power Adaptor
Figure 1-15
17