Connecting The Camera; Power Connection; I/O Device Connections - GeoVision GV-VD120D Quick Start Manual

2.4 Connecting the Camera

Connect your Vandal Proof IP Dome to power, network and other wires
needed.

2.4.1 Power Connection

There are two ways to supply power to the camera:

Use a Power over Ethernet (PoE) adapter to connect the camera to the
network, and the power will be provided at the same time.

Plug the power adapter to the terminal block by inserting the striped
wire to the right pin (-) and the black wire to the left pin (+).

2.4.2 I/O Device Connections

The camera supports one digital input and one digital output of dry contact.
I/O
1
Figure 2-21
For details on how to enable an installed I/O device, see 4.3 I/O Settings,
GV-IPCam Firmware Manual.
Figure 2-18
2 3
Vandal Proof IP Dome (Part II)
2
Pin Function
1 Digital Output
2 GND
3 Digital Input
41