Using The Leds To Locate The If2; Restoring The If2 To The Default Configuration - Intermec IF2 User Manual

Chapter 4 — Managing, Troubleshooting, and Upgrading the IF2
60

Using the LEDs to Locate the IF2

You can use the LEDs to help locate a specific IF2 in your location.
To locate an IF2
• In the About This IF2 RFID Reader screen, click Find This
Device. All of the LEDs except the Power and Wired LAN LEDs
flash. Click Finished Finding This Device to turn off the LEDs.

Restoring the IF2 to the Default Configuration

Note: Restoring default settings as described in this section does not
affect security certificates you have installed.
There are four ways to restore the default configuration on the IF2:
• You can restore default settings from the web browser interface.
For help, see the next section.
• You can restore default settings by pressing the reset switch
located on the top of the IF2.
• You can restore default settings via a serial connection. For help,
see "To restore defaults via a serial connection" on page 62.
• You can restore default settings using the Device Configuration
Web Services. For help, see the
Command Reference Manual.
Device Configuration Web Services
IF2 Network Reader User's Manual