Parameter Assignment/Addressing; Parameters - Siemens SIMATIC ET 200SP Manual

Parameter assignment/addressing

6.1

Parameters

Parameters of the AS-i master
Table 6- 1 Assignable parameters and their default setting (GSD file)
Parameters
Diagnostic interrupt in case of errors in AS-i configuration
Diagnostic interrupt in case of AS-i cable fault
Automatic address programming
Ground-fault monitoring activated
Automatic ID1 code assignment (Firmware V1.1 and
higher)
Duplicate address detection
1) This parameter is divided into "Deactivate duplicate address detection" and "Duplicate address detection for 24 V"
depending on the GSD variant.
AS-Interface master CM AS-i Master ST (3RK7137-6SA00-0BC1)
Manual, 07/2017, A5E02655262020A/RS-AD/004
1)
Value range
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable for AS-i voltage
•
24 V
Enable for AS-i voltage
•
30 V
Disable
•
6
Default
Enable
Enable
Enable
Enable
Disable
Disable
43