Configuring; Requirements - Siemens SIMATIC ET 200SP Manual

Configuring

5.1

Requirements

Introduction
You configure the ET 200SP station and its CM AS-i Master ST and assign their parameters
using
Configuring the CM AS-i Master ST
Configuring in
AS-i Master ST in an ET 200SP. A distinction is made here between the necessary basic
configuration of the AS-i master and the optional configuration of the AS-i slaves.
You can configure the module using
Table 3-1 Version dependence of the CM AS-i Master ST engineering versions (Page 17)
Note
CM AS-i Master ST in the hardware catalog of
If the CM AS-i Master ST module in the applicable firmware version is not listed in the
hardware catalog of
this HSP from the Internet using the corresponding function in
Further information can be found in the documentation and in the online help for
Installing the HSP in
Installing the HSP in
(TIA Portal):
You can find additional information on the HSP and download it in Internet
(https://support.industry.siemens.com/cs/ww/en/view/108742051).
Download the GSD file from the internet:
PROFINET GSD file (https://support.industry.siemens.com/cs/ww/en/view/57138621)
PROFIBUS GSD file (https://support.industry.siemens.com/cs/ww/en/view/73016883)
Observe the
manufacturer.
AS-Interface master CM AS-i Master ST (3RK7137-6SA00-0BC1)
Manual, 07/2017, A5E02655262020A/RS-AD/004
STEP 7
or the configuration software of another manufacturer.
STEP 7
or another configuration software is required in order to use the CM
STEP 7
, you will need a "Hardware Support Package". You can install
STEP 7
STEP 7
STEP 7
online help or the documentation of the configuration software
STEP 7
or with a GSD file. Version dependencies:
STEP 7
V5.5 (classic) "HW Config" > "Options" menu > "Install
HW Updates"
V13 "Options" menu > "Support packages"
STEP 7
.
STEP 7
5
.
29