Siemens SIMATIC ET 200SP Manual page 137

Table 9- 37 Structure of flag 1 and flag 2
Bit Meaning
number
0 Config_OK
1 LDS.0
2 Auto_Address_Assign
3 Auto_Address_Available
4 Configuration_Active
5 Normal_Operation_Active
6 APF
7 Offline_Ready
1) The "Configuration_Active" and "AUTO_ADDR_ENABLE" flags change the operating mode of the AS-i master. The
values of the remaining flags are insignificant for the command "Set_LPS, Set_PCD, Set_PP, Set_Flags" and cannot be
modified in the AS-i master by this call.
Configuration_Active
AUTO_ADDR_ENABLE
For the meanings of flags, refer to Chapter:
No. B0: Get_LPS, Get_LAS, Get_LDS, Get_Flags (Page 122)
AS-Interface master CM AS-i Master ST (3RK7137-6SA00-0BC1)
Manual, 07/2017, A5E02655262020A/RS-AD/004
Flag 1
1)
"0" means:
After the command has been executed, the AS-i master will switch to "protected operation".
"1" means:
The AS-i master runs in "configuration mode" after completion of the job.
"0" means:
Automatic address programming is disabled.
"1" means:
Automatic address programming is enabled.
Using the command interface
9.4 Description of the AS-i commands
Flag 2
Bit Meaning
number
0 Periphery_OK
1 Data_Exchange_Active
2 Off_Line
3 AUTO_ADDR_ENABLE
4 Earth_Fault
5 EEPROM_OK
6 EFD-ENABLE
7 Reserved
1)
137