Table of Contents
Advertisement
6.3
Switching on the device.
6.3
Procedure
1. Plug the mains connector of the supplied power supply cable in the AC power supply
2. Screw on the lock for the mains connector (1).
Figure 6-1
3. Lock the mains connector in place as shown in the illustration.
4. Plug the power supply cable into a socket with a grounded protective conductor.
5. Switch on the power switch of the device.
SIMATIC Panel PC 577
Operating Instructions, Release 04/2006, A5E00798484-01
connector of the device.
Lock mains connector
The device starts up and boots. If it does not, use a pointed object to press the soft power
key.
Note
Soft power key
For further instructions on using the soft power key, refer to the section "Operator control
/ Command elements".
Commissioning
6.3 Switching on the device.
6-5
Advertisement
Table of Contents
