Table of Contents
Advertisement
Planning use
3.5 Mounting positions and fastening
3.5
Mounting positions and fastening
3.5
3.5.1
Installation instructions
Before mounting the device, read the following general notes relating to installation.
Warning
Dangerous Voltage
Isolate the power supply to the control cabinet before opening it. Ensure that the power to
the control cabinet cannot be turned on accidentally.
Caution
The device is approved for operation in closed rooms only.
• Ensure that the grounding outlet of the building installation is easily accessible and that
• Position the screen in an ergonomic position favorable to the user. Choose a suitable
• Position the screen so that it is not subject to direct sunlight or other strong sources of
• DVD drives are susceptible to shock. Shocks during operation can lead to the loss of data
• Applies to devices which are installed in swivel arm housings: Avoid rapid or jerky
• Provide adequate volume in the control cabinet for air circulation and heat transport.
• Do not allow the maximum air intake temperature to exceed 45° C. Decisive is the
• Position the device so that the air vents of the housing are not covered up following
• Ensure there is enough free space in the control cabinet to allow the sheet metal cover to
3-6
there is a mains disconnect switch in control cabinet installations.
mounting height.
light.
or damage to the drive or data carrier. Burners and DVDs are not suitable for continous
operation.
movements of the swivel arm during operation. The ensuing forces could lead to possible
irreversible damage of the hard disk.
Keep at least 10 cm distance between the device and control cabinet.
temperature measured at a distance of 10 cm from an air intake. The maximum air intake
temperature must be accounted for especially when sizing closed control cabinets.
mounting.
be removed. You will otherwise have to remove the device from the control cabinet or
swivel arm when replacing the memory or the battery.
Operating Instructions, Release 04/2006, A5E00798484-01
SIMATIC Panel PC 577
Advertisement
Table of Contents
