Siemens simatic PC 577 Operating Instructions Manual page 137

Procedure
1. Format and partition the hard disk drive as required.
2. Transfer the backed up data back to drives C and D using the backup utility. Use the
3. You can also install an operating system yourself.
4. Install the required Windows service packs and security updates. Refer to the
5. For new Windows 2000 installations, install the chipset driver before installing any other
6. The following applies if you are installing Windows XP SP1 on the Panel PC without the
7. Install any other required drivers.
8. If you install an operating system yourself, install all of the required drivers and
9. Install any other required software.
10. Configure the drivers and applications as needed. For more information, refer to
11. Save the hard disk data to a DVD-ROM or network drive.
SIMATIC Panel PC 577
Operating Instructions, Release 04/2006, A5E00798484-01
Restore CD, for example, to transfer the original image back to the device's hard disk.
"Commissioning" section for more information.
drivers.
Restore CDs:
Caution
Maloperation
Install Microsoft update KB822603. Otherwise, the USB interfaces and therefore the
touch and key operation may not work correctly.
You can download the update and obtain additional information in the Internet at
"http://support.microsoft.com".
applications.
"Additional drivers and applications" in the control unit operating instructions.
Note
To verify that the data on the DVD-ROM is in order, transfer the data on the DVD-ROM
back to an empty hard disk and quickly test the device by switching it on.
Servicing and maintenance
10.3 Installing software
10-39