Planning use
3.6 Mounting cut-out
3.6
Mounting cut-out
3.6
3.6.1
Selecting and creating the mounting cut-out
Requirement
The degree of protection suitable to the field of application and thereby the mounting method
have been selected.
Procedure
1. Follow the installation instructions.
2. Select a location suitable for installation, taking into account the installation instructions
3. On the basis of the dimensional drawings, check whether the required screw and
4. Complete the mounting cut-out in accordance with the dimensions. You can also obtain
3-10
and the chosen mounting position.
pressure points on the rear and the hatched seal area are easily accessible after the
completion of the mounting cut-out. Otherwise the mounting cut-out is useless.
these dimensions from the mounting template supplied with the device.
Operating Instructions, Release 04/2006, A5E00798484-01
SIMATIC Panel PC 577