Table of Contents
Advertisement
Figure 10-11 Processor
6. Lift the processor (2) out of the slot.
Reverse the procedure to install the processor and hear sink. The processor will be
automatically detected by the BIOS.
Caution
Insert the new processor into the slot so that the notch on the processor matches the
marking on the processor slot (3). Swing the lever (1) downwards until it clicks into position.
Ensure that the processor (2) is covered with a thin transparent layer of heat conductive
paste. Clean the hear sink if necessary and apply new heat conductive paste before
installing it.
If the heat sink has a heat conductive pad (a rubbery foil), use the heat conductive pad
instead. Only use a heat conductive pad once.
SIMATIC Panel PC 577
Operating Instructions, Release 04/2006, A5E00798484-01
10.2 Removing and installing hardware components
Servicing and maintenance
10-25
Advertisement
Table of Contents
