Table of Contents
Advertisement
Procedure
1. Follow the installation instructions.
2. Drill suitable holes at the prepared mounting cut-out in accordance with the specifications
3. Carefully drill the respective holes in the control unit at the designated location (1) from
Figure 4-2
Designated location for holes on the control unit
4. Working from the front, insert the device into the mounting cut-out.
5. Secure the control unit by inserting suitable screws through the holes and attaching nuts.
SIMATIC Panel PC 577
Operating Instructions, Release 04/2006, A5E00798484-01
for L4 and L5, as shown in the mounting cut-out in the dimensions.
the rear.
Installation
4.2 Securing with screws
4-3
Advertisement
Table of Contents
