Loading Films - AGFA Drystar AXYS Manual

D AXYS
RYSTAR

Loading films

This section describes how to load the Drystar AXYS with appropriate
Drystar DT 2B and Drystar DT 2C films.
The Drystar AXYS can be loaded with 8x10", 10x12", 11x14", 14x14" and
14x17" films.
The Drystar AXYS will inform you in several ways when a film tray is empty:
an audible signal,
the status indicator LED is blinking (red color),
the display screen shows a message informing you that the input tray is empty.
The film loading procedure is identical for both input trays. In the examples
below, we will assume that the lower input tray is to be loaded.
76
Note: The Drystar AXYS can be loaded with new films in full daylight. Loading
films is easy and can be done very quickly. Follow the procedures as described in
this section.
Note: If you want to change the film format, the tray configuration must be
modified. Refer to "Changing the film format of the trays"
information.
Note: The procedure is slightly different, depending on the fact whether the
Drystar AXYS is printing/calculating or in the ready state.
Note: When the printer is in the ready state, go to
ready state and an input tray is empty"
WARNING: Make sure not to load more than one film pack in an input
tray. Loading more than one film pack in the input tray may damage the
Drystar AXYS.
on page
"When the Drystar AXYS is in the
on page 78.
2852 A EN 20070205
32 for more