AGFA Drystar AXYS Manual page 5

D AXYS
RYSTAR
Key-operator mode
In key-operator mode, operation is menu driven. The menu displays the key-
operator functions.
5 Restore config.
6 Calibration
7 Service Actions
8 Quality Control
9 Installation
The display shows only four lines. In the above figure, they are indicated in the
upper zone. The other possible lines are shown in the lower area and can be
reached by scrolling using the Up/Down arrow keys on the Keypad.
The active keys are indicated by their respective LEDs.
Data entry
When entering numerical or alphanumerical data, always adhere to the follow-
ing principles:
Only (alpha) numerical data can be entered.
During data entry, the field is displayed in reverse mode.
Increment the number in a(n) (alpha) numerical entry field by pressing the Up
key. Transition from 9 to 0 of one figure will also increment the next figure to
the left, respecting the valid limits of the range.
Decrement the number in a(n) (alpha) numerical entry field by pressing the
Down key. Transition from 0 to 9 of one figure will also decrement the next fig-
ure to the left, respecting the valid limits of the range.
Move the entry position in a(n) (alpha) numerical entry field from right to left
by pressing the Left key.
Move the entry position in a(n) (alpha) numerical entry field from left to right
by pressing the Right key.
Press and hold down a key to repeat arrow key actions.
To accept an entry in a menu, press the Confirm key.
58
Visible
Reachable with Up/Down arrow keys
2852 A EN 20070205