Viewing The Film Count Info - AGFA Drystar AXYS Manual

D AXYS
RYSTAR

Viewing the film count info

When the Drystar AXYS is printing, you can always view the number of films
left in the trays by entering the operator menu.
During a print job, the 'print' screen is displayed:
Mod.name
To view the number of loaded films in the trays, proceed as follows:
1 Press the Escape key to enter the operator menu.
The 'Operator menu' screen appears:
2 Press the Down key once, followed by the Confirm key to select 'Film count
info'.
The following screen appears:
The progress bar indicates the evolutions of the film usage in an input tray. The bar is
divided into 10 parts, each part represents approximately 10% of the total films of a
film pack. The last part of the bar will disappear when more than 80% of a film pack
has been printed.
3 Press the Confirm key to return to the print screen.
70
WARNING: Do not open the input trays to view the number of loaded
films while the Drystar AXYS is printing, but follow the procedure below:
PR
1 2
Note: When a film job cannot be done because the tray to which the job is assigned
is empty, then the printer will check if the films in the other tray can be used for
this and other print jobs in the print queue. The printer will skip the print jobs that
cannot be done and will resume them later.
2852 A EN 20070205