AGFA Drystar AXYS Manual page 29

D AXYS
RYSTAR
8 Tear the plastic strip around the film pack.
9 Close the input tray.
82
Note: The Drystar AXYS resumes printing as soon as the tray is closed.
Note: Loading instructions are also available on the input tray cover.
Note: Never load another film format when the input tray is not empty.
Intermediate changing of film formats increases the risk for dust, which can
damage the thermal print head (TPH).
Note: The system performs an automatic calibration when the film format has
been changed.
Note: When a film job cannot be done because the tray to which the job is assigned
is empty, then the printer will check if the films in the other tray can be used for
this and other print jobs in the print queue. The printer will skip the print jobs that
cannot be done and will resume them later.
Note: When a film sheet is inserted wrongly in the input tray, then the printer will
print on the back-side (non-emulsion side). As a result, a film jam occurs.
Note: The operator will be informed of this back side printing and will be asked to
remove the film jam (refer to
whether the loading procedure was followed correctly (refer to
procedure" on page 79).
WARNING: Never reuse a jammed film. Refer to
on page 129.
"Clearing of film jams" on page 129) and to check
"Film loading
"Clearing of film jams"
2852 A EN 20070205