Test Mode; Remote Operator Interface - HP Series 37 Reference Manual

Opera ting Instructions
TEST MODE
The Test Mode allows the System Operator to select portions of the Power-on Self Test or an additional
CPU test wit., failures displayed on the System Console. The Test Mode also allows for looping up to
9999 times, the default
is
I.
The Maintenance mode TEST command accesses the Self Test mode. Table 2-4 lists the commands
available in Test Mode.
REMOTE OPERA TOR INTERFACE
The remote System Operator interface is enabled if all of the following conditions are met:
• The Console is connected to Port 7 of TIC in Slot I via modem or hardwi
,'?
configuration.
• The keyswitch is in Remote (or Local after having been in Remote, but not s\'(;tched through
Normal) mode and the REMOTE LED is on.
• The System Console, the modem, and the remote como Ie are all operating at the same baud
rate.
• The hardwire configuration requires a standard
25
pin straight through
mod~m
cable with
pins 4 and 22 to be tied together.
Table 2-4. Test Mode Commands
r - - - ' ------------~--------------------------------------.--------------_.
Command Description
~'------------~------------------------------------------------------1
ALL
CHANNEL
CPU
EXIT
HELP
IOMAP
MEMORY
PON
Run all self tests 1-9999 times.
Loop Test of channel 1-9999 times.
Loop CPU test 1-9999 times.
Return to Maintenance Mode.
Lists Test Mode Commands and display ROM version numbers.
Loop IOMAP 1-9999 times.
Loop memory test 1-9999 times.
Run (or loop) Power-on Self Test.
NOV 84
2-5/6