Test Mode Commands; All - HP MICRO 3000 Diagnostic Manual

L _ ..
T_E_S_T_M_O_DE ________________
~1~14i1H,
_COMMAND DESCRIPTIONS _
INTRODUCTION
This section provides a definition of test mode and a description of test mode commands.
Test mode allows the system operator to initiate and manually direct the self tests. Test mode allows for
looping up to 9999 times; the default is 1. Looping is disabled when the keyswitch is
in position
111"
(NORMAL).
Use the maintenance mode TE [s t] command to enter test mode.
Error messages can be found in Appendix
A.
TEST MODE COMMANDS
Test mode allows you to enter the following commands at the "Test ->" prompt:
All
All
Channel
CPU
Exit
Help
IOMAP
Memory
PON
The ALL command runs all of the manually directed self tests except the PON test in the following order:
• CPU test
• Memory test
• Channel test
• IOMAP
DEC 86