Newsystem; Panel; Reload - HP Series 37 Reference Manual

Command Descriptions
The load is performed with the normal operator (INITIAL) dialogue allowing for changes to the software
configuration.
The correct syntax for this command is:
LOAD [chan,device] [{P[erm]},{C[hange]}]
Newsystem
The
NEWSYSTEM
command operates like the
LOAD
command with the following exceptions:
• No
ohannel
or
de/Jioe
parameters are allowed.
o The default LOAD device is always used .
• This command will only work with a FOS tape built especially for the Series
37.
If
NEW
is
attempted with other RELOAD tapes, the operator (INITIAL) dialogue will be invoked by
INITIAL.
This command performs a RELOAD function ~l·asing any existing user files
on the system discs.
It
should be used only for the initial software
installation.
The correct syntax for this command is:
NE[wsystem]
Panel
The
PANEL
command enters the Softpanel Mode. The commands available in Softpanel Mode are
described in Section IV "SOFTPANEL".
Reload
The
RELOAD
command operates exactly like the
LOAD
command with the following exceptions:
Q
No
channel
or
device
parameters are a!!cwed.
~
The default LOAD device is always used .
.. No opportunity is given to change the software configuration (no INITIAL dialogue).
The corn'ct syntax for this command is:
REL[oad]
NOV 84
3-5