Printing Messages; How To Run Picdiag - HP Series 37 Reference Manual

Operating Instructions
2.4 PRINTING MESSAGES
There are two types of messages: error and information.
The three types of error messages are described above. The default configuration enables error messages
(EEPR).
To suppress error messages, type
SEPR.
Information messages describe the progress of the diagnostic or tell you to perform an operation. The
default configuration enables information messages
(ENPR).
To suppress information messages, type
SNPR.
The messages are displayed on the console by default. To direct the error messages to a hardcopy device,
type
PRINTER.
Non-error messages cannot be directed to the printer.
2.5 HOW TO RUN PICDIAG
Input to the PICDIAG is through the system console.
Run PICDIAG in the following manner:
1)
Perform MPE shutdown to log off all users, if applicable.
2) Run the console self test.
3) Fully reset the console.
4) Install a DUS tape in the cold load device.
5) If the system is off, power it on by turning the keyswitch to the LOCAL or REMOTE position. If the
system is already on, verify that the keyswitch is in the LOCAL or REMOTE position. Use the
appropriate load command to load the DUS.
6) DUS displays a welcome message and a prompt:
DIAGNOSTIC/UTILITY SYSTEM (REVISION
nn.nn)
ENTER YOUR PROGRAM NAME (TYPE HELP FOR PROGRAM INFORMATION)
7) Type
PICDIAG
in response to the prompt.
8) PICDIAG loads, then displays the following message:
PICDIAG xX.xx
Default tests are 1-39,41-45. Optional test is 40.
SEP 84
2-3