Error Codes; Tic Error Codes; A-I; Tic Test Section 1 - HP Series 37 Reference Manual

Error Codes
I-
I
A
I
~
________________________________________________________________
~"
I
This appendix will cover all error codes associated with the Series 3 7 Self Test. The error codes are listed
according to the test sequence they are associated with: TIC, PIC, CPU, or MEMORY.
TIC ERROR CODES
The TIC error codes are divided according to one of the nine sections of the TIC test that detected the
error.
The Slot Test will display one of the following error codes if the TIC test fails. Note that the Tests are run
in the same sequence as the test sections and that the test stops on the first failure found.
TIC Test Section 1
This is the initialization test. It will initialize the TIC and then check that the registers contain expected
data.
Code Error
0108
Register 8 initialization error (expected $0800)
0109
Register
9
initialization error (expected $0800)
010A
Register A initialization error (expected $FFOO)
010C Register C initialization error (expected $0000)
0100 Register D initialization error (expected $ 0000)
010E Register E initialization error (expected $ 5004)
010F Register F initialization error (expected $5004)
TIC Test Section 2
This section performs tests on: basic operations, test OBII, IPOLL, SMSK & KMSK.
Code Error
0201 SMSK/RMSK test, TIC did not respond with mask bit set
0202 SMSK/RMSK test, TIC did not respcnd v!ith mask bit cleared
0203 TIC did not set IRQ
0204 Improper IPOLL response (no, wrong, or multiple channels)
0205 Improper OBn response
NOV 84
A-I