Pic Test Section 3 - HP Series 37 Reference Manual

PIC Test Section 3
Test ABI Status Register (PIC Register 1)
Code Error
0301
Initialization error - bits 0 to 7 should be Zero
0302 Initialization error - bits 10, 13, and 14 should be Zero
and bits 11 and 1 2 should be One
0303 Bit 13 should be I, bit 14 should be 0 when the ABI is
addressed to Talk, but not Listen.
0304
Bits 13 and 14 should both be 1 when the ABI is addressed
to Talk and Listen.
0305
Bit 14 should be !, bit 13 should be 0 when the ABI is
addressed to Listen, but not to Talk.
0306 Bits 13 and 14 should both be 0 when the ABI is not addressed
to Talk or to Listen.
PIC Test Section 4
Test ABI Interrupt Register (PIC Register 2) and Interrupt Mask Register (PIC Register 3)
Code Error
0401
Reg2, Bit 0 should be set (an interrupt is pending).
0402 Reg2, Bits 9 and 13 should be clear
(no handshake abort and inbound FIFO empty).
0403
Reg2, Bit 12 should be set (outbound FIFO room available).
0404 Reg2, Bit 14 should be set (outbound FIFO idle).
0405 Reg2, Bit 8 should be clear (no status change).
0406 Reg2, Bit 0 should be clear (no interrupt pending).
0407 Reg2, Bit 8 should be set (status change occurred).
0408
Reg2, Bit 9 should
be
clear (no handshake abort).
0409
Reg2, Bits 12 and 14 should be clear. Bit 13 should be set
(outbound FIFO room not available, outbound FIFO not idle,
and inbound FIFO not empty. =~> FIFO bits in opposite
state).
040A
~eg2, Bit 9 should be set (handskake abort).
040B Reg2, Bit 9 should be clear (no handshake abort).
Error Codes
NOV 84
A-5