Memory - HP Series 37 Reference Manual

Command Descriptions
The following illustrates the use of IOMAP:
1-NORMAL
Test
->!
System I/O Configuration
Number of banks
=
4
Load: Cilannel 4 Device 3
Start/Dump: Channel 4 Device 1
Slot
1 Channel
Slot 4 Channel 4
Dev ice 3
10=0260
1-NORMAL
Test
->
10=4 -
Terminal Interface Controller
10=2 -
Peripheral Interface Channel
- 9144 Cartridge TapP. Unit
Memory
The Test Mode MEMORY command ~xecutes the Power-on Memory Test which first determines the amount
of memory installed, initializes the memory, performs an Address Test, performs a Pattern Test, and then
performs an Error Detection And Correction Test (EDAC). The memory is left with 30F8 (halt 8) in all
locations.
The full memory test is run and a pass/fail message is sent to the System Console. If a failure occurrs the
number of the failing section
is
displayed.
The test may be looped by specifying the desired number of loops in oount. Count must be an integer
between I and 9999 with I being the default. A space is required before specifing oount.
Return is to the Test Mode prompt.
The correct syntax for this command is:
M[emory] [ oountJ
The following illustrates the use of
MEMORY:
'\lOV 84
3-14
1-NORMAL
Test
->~
Memory Test passed
1-NORMAL
Test
->