Cbss Front Panel Without Bezel - Hitachi G200 Hardware Reference Manual

5
6
Note: Removing a controller can cause the POWER, READY, WARNING, and
ALARM LEDs on the front panel to turn off. These LEDs return to their on state
after the storage system recovers from the controller replacement.

CBSS front panel without bezel

The following table describes the definitions of the CBSS controller front
panel LEDs.
1
2
3
4
5
Hitachi Virtual Storage Platform G200 Hardware Reference Guide
Number
POWER ON/OFF (main switch)
Lock
Number
ACT LED
ALM LED
POWER, READY, WARNING, and
ALARM LEDs
POWER ON/OFF (main switch)
Small form factor drives
Virtual Storage Platform G200 controllers
Item
https://support.hds.com/
en_us/contact-us.html.
Powers the storage system.
Locks and unlocks the front
panel bezel by using the
supplied key.
Item
Green: Normal operation.
Blink green: Drive is being
accessed.
Red: Drive stopped due to a
failure and can be replaced.
Note: When System Option
Mode 1097 is set to ON, the
WARNING LED does not blink,
even if the following failure
service information messages
(SIM) are issued: 452xxx,
462xxx, 3077xx, 4100xx, and
410100.
Powers the storage system.
The twenty-four 2.5-inch small
form factor drives are
Description
Description
27