Hitachi G200 Hardware Reference Manual page 117

Item
Network switch
Switch cascading
MAC address
Maximum transfer unit (MTU)
Link aggregation
Tagged VLAN
IPv4
IPv6
Subnet mask
Gateway address
DHCP
DNS
Ping (ICMP ECHO) Transmit,
Receive
2
IPsec
TCP port number
iSCSI standards and specifications
Hitachi Virtual Storage Platform G200 Hardware Reference Guide
Specification
L2 or L3 switch
Maximum: 5 switches or fewer
Per port (fixed value)
1,500, 4,500, 9,000 bytes
(Ethernet frame)
Not supported
Supported
Supported
Supported
Supported
Supported
N/A
N/A
Supported
N/A
3260
Comments
Should comply with
IEEE802.3ae
Minimum number of cascading
switches is recommended.
Factory setting: World Wide
Unique value. Cannot be
changed.
Jumbo frame, MTU size greater
than 1500
N/A
N/A
N/A
Note the following precautions:
• When iSCSI Port IPv6 is set
to Enabled, if the IPv6
global address is set to
automatic, the address is
determined by acquiring a
prefix from an IPv6 router.
• If the IPv6 router does not
exist in the network, the
address cannot be
determined. As a result, an
iSCSI connection might be
delayed. When an iSCSI
Port IPv6 is set to Enabled,
verify the IPv6 router is
connected to the same
network, and then set IPv6
global address
automatically.
N/A
N/A
N/A
N/A
N/A
N/A
Changeable among 1 to
65,535. Observe the following if
changing values:
• The setting of the
corresponding host should
also be changed to log in
the new port number.
117