Maternal Monitoring Alarm Messages; Patient Alarm Messages - EDAN F6 User Manual

F Series Fetal & Maternal Monitor User Manual
SpO
2
NIBP
HR
TEMP

10.5 Maternal Monitoring Alarm Messages

Besides the fetal monitoring alarms, F6 Express/F9 Express also gives alarms for the situations
that occur during maternal monitoring. The alarm messages are listed below.

10.5.1 Patient Alarm Messages

Alarm Message
High Level
***ASYSTOLE
Medium Level
**HR HIGH or
**HR xxx > yyy
**HR LOW or
**HR xxx < yyy
** SpO HIGH or
2
** SpO xxx > yyy
2
** SpO LOW or
2
** SpO xxx < yyy
2
99: Current SpO
: SpO indicator.
2
SI: Signal intensity.
09:15: Time when the NIBP measurement starts.
mmHg/kPa: NIBP unit.
From left to right in turn: systolic pressure (118) and diastolic pressure
(73).
(manual)/(Auto): The current NIBP measurement mode.
(ECG)/(Pulse): The current HR source.
60: Current maternal heart rate measurement numeric.
(ºC)/(ºF): TEMP unit.
37.2: Current TEMP measurement numeric.
Source Cause
No QRS wave is detected in 4
ECG
seconds
ECG/
Maternal HR result (xxx) is higher
than the upper limit (yyy).
Pulse
ECG/
Maternal HR result (xxx) is lower
than the upper limit (yyy).
Pulse
SpO result (xxx) is higher than
2
SpO
2
the upper limit (yyy).
SpO result (xxx) is lower than the
2
SpO
2
upper limit (yyy).
measurement numeric.
2
- 109 -
Maternal Monitoring Display
Countermeasure
Check the patient's condition
and take necessary measures.
Check if the alarm limits are
suitable; check the patient's
condition.