SunStar SPS/S-CV1 Manual page 26

4.5.6) Setting X-Y axis starting points
1) Setting up Y-axis starting point
Move the center of feed plate to be in the middle
toward X-axis.
Loosen X-censor bracket nut to be the center of
censor, and then tighten fixing screw.
2) Setting up Y-axis starting point
Move the center of feed plate to be in the middle
toward Y-axis
Loosen Y-censor bracket nut to be the center of
censor, and then tighten fixing screw.
26
X sensor plate
Turnbuckle
X censor plate
Sensor
Nut
Sensor