Install Wire Harness To Chute Harness - Briggs & Stratton 1695360 Operator's Manual

Install Wire Harness to Chute Harness

1. Connect the switch wire harness (a, Figure 27) to the
chute wire harness (N). Secure wire harness to tractor
frame using clip (O).
a N
Figure 27
2. Connect the wire harness (b, Figure 28) to the
snowthrower motor plug (c). Secure wire harness to
snowthrower using zip tie (P).
P
Figure 28
Note: The chute wire harness SHOULD NOT come in
contact with the muffler.
For 2013 Models & Proceeding Years (Electric
Height-of-Cut Units)
1. Locate the electric height-of-cut harness (a, Figure 29)
underneath tractor.
NOTE: This harness was disconnected when mower
was removed.
2. Connect the electric height-of-cut harness to the chute
O
rotation harness (N).
Figure 29
3. Secure harness wires to tractor frame using a zip tie (P,
Figure 30).
c
Figure 30
b
Assembly
N a
P
17